Warp Factor 9! - Printing the PP3DP (UP!) Bearing on My Repstrap
SEPTEMBER 20, 2010
So maybe a bit over ambitious for a Repstrap with no Heated bed but I had a go anyway. I really like the UP! Bearing - get it here - [link] Not a bad start - Poor choice of infill size - too many start-stop operations Starting to warp on the front edge - Note my use of double sided tape! in a poor attempt to counter the warp. At this point the warp was going to destroy my extruder, so I reluctantly had to turn it off. You can see the bottom front edge getting more and more melted after each pass.